Bobbing Compound Pre-Polish Compound Removes Scratches and Scale Bar

Description

BOBBING COMPOUND
CLEAN AND PREP METAL SURFACE
1 BAR - TAN ORIGINAL FORMULA
METAL BUFFING COMPOUND MATERIAL
Bobbing Compound has a slightly greasy composition with light abrasion, formulated for pre-polishing, a cleaning and surface preparation buffing compound with a light cutting ability.
Bobbing compound is used for pre-polishing of non-ferrous metals including precious metals such as gold and silver will clean the surface leaving a dull outer surface.
Its composition is made for removing fine scratches abrasive lines, removing fire scale t marks on metal surfaces, recommended to remove and eliminate scratches and imperfections.
Bobbing Compound
is always the
first step
in the polishing process,
used primarily with brushes, felt and muslin wheels to
remove fire scale and scratches, preparing the piece for the final polish with rouges
.
NOTE:
We have included polishing recommendations at the bottom of this page, to assist you.
BOBBING COMPOUND
JETS Product # 1614-302
Made in USA
Bars Size:
6" x 2" x 1-1/4"
-
150mm x 53mm x 32mm
Bar Weight:
Approximately 12oz. / 328gr +/-
·
Utilizes Quality Grade Abrasives
·
Combined with Additives
·
Long Lasting Composition
·
Good Adhesion to Buffing Wheels
·
Minimal Residue
·
Cleans and Leaves Dull Surface
·
Produces - Light Cut of Surfaces
SALE
IS FOR 1 BAR
SHIPPING: Via USPS MAIL FIRST CLASS MAIL
NOTE: Visit
JETSTOOLS
ebay Store Listings, where you can see the compounds for various Metals and Applications, Polishing Compounds, Felt and Muslin Buffs and Buffing Wheels and a selection of
J
ewelers
E
quipment
T
ools
&
S
upplies
.
JETS Inc.
POLISHING RECOMMENDATIONS:
Our recommendations and suggestions on Buffing to obtain the best results possible:
·
Use the right compound for the metal that you are trying to polish
·
It may be needed to go through 2 or 3 steps, in polishing to get the optimum result you are looking to achieve.
·
Make sure that the parts that are being polished are smooth and clean, use the appropriate abrasive to remove lines and scratches.
·
Avoid using different compounds with the same buff, if you have to then make sure to clean and remove any hardened compound residue on the surface edge with a buff rake.
·
Segregate your buffs for the various metals, Gold, Silver, Brass … try not to use the same buff for all metals.
If you have to then make sure buffs are cleaned (dressed) with a buff rake.
·
A clean buffing wheel edge is important.
·
Allow the buff and compound to perform the work they were made and formulated for, excessive force or pressure will hurt the process.
·
Whenever you are working with Platinum never use a buff that was used for another type of metal.
WORK SAFE!
Working with rotary motors and wheels can be dangerous if proper safety procedures are not followed
.
PROTECTION -
Protect yourself, your fingers and hands, your face and eyes and use respirators
.
1012  E13 CKSP M P